Special Device; Working Light; Manual Machine Control; Ruler - AMF S-100 Parts And Service Manual

7 . S P E C I A L D E V I C E
7.1. Working light –
- order number 12.0008.4.875
7.2. Manual machine control —
- order number 03.5519.0.007
- allows to change the foot machine control for manual
by switch installation on the table and changing the
cables
7.3. Ruler ˜
- order number 03.5511.0.003
7.4. Voltage control - relay HRN 35 ™
- order number 06.1900.0.000
The machine operation is ensured when the power supply is in range AC
230V
± 10 % (EN 60204-1). The manufacturer recommends to equip the
machine with the relay HRN-35 in case of larger fluctuation of power
supply.
It prevents the machine from damage and in case of large decrease of power supply, the
operator is informed by error message.
If the power supply range is exceeded - max 250V and min 190V the voltage guard -
relay HRN-35 which ensures that machine does not start. After the power supply is in
required range, it is possible to start the machine.
7.5. Thread nipper š š š š š
- order number 03.5519.4.013
This equipment is used to hold the upper thread at the beginning of
sewing cycle.
It eliminates the skipping of stitches at the beginning of sewn but-
tonhole, especially when sewing the fly bar.
It is supplied as standard to the following versions: LTT, AF+I and
CT+I ( Indexer for sewing the jackets ).
Revised 02/2009
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
A
INTRODUCTION
-
–
—
˜
š
S-311
™
1-9