B - Machine Assembly; Content Of The Shipping Box - AMF S-100 Parts And Service Manual

S-311
1 . C O N T E N T O F T H E S H I P P I N G B O X
1.1. If it is not mentioned otherwise during ordering, the shipping
container usually contains:
1.2. When unpacking the container, follow labels which are on a cover.
CAUTION: If the container was damaged during the transport, inform the carrier. Check the contents
of the container with order. In the event of an error, immediately inform the manufacturer- late
notification of an error in shipment may result in loss of claim.
2. TA B L E A D J U S T M E N T
2.1. After you will unpack the machine, move the machine to its appointed place. The machine is
supplied with the stand with standart height for working in seat. For another stand
implementation is necessary to make an agreement with the customer. The recommended height
of the stand (table) is 870 mm. Tighten the screws — very well.
2.2. To stabilize the table, use the floor pads
levelness of the adjusted table.
2.3 Eliminate the shipping band
different location, it is necessary to fasten the table to prevent shifting in transit.
1-10
B
- MACHINE ASSEMBLY
— assembled machine on the stand with
electroinstalation
— box with the accessories
(specification in the spare parts
section)
— dis-assembled thread stand
— operation manual with the spare parts
manual
š
, which holds the head in place. If transporting machine to a
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
– – – – –
˜
, which are controlled by hand screw
– – – – –
™
. Check the
Revised 04/2007