Spreaders Adjustment - AMF S-100 Parts And Service Manual

E
1 2. S P R E A D E R S A D J U S T M E N T
To reach this, rotate the hand wheel.
12.1. Adjust the right spreader Ÿ to the right looper edge ž, the left spreader
the hole of the left looper ›. To adjust, loosen the screws
can not slacken.
12.2. Check the clearance between the loopers and spreaders (it must be minimal).
Right - 0,05 mm maximum, so the sewing thread does not go between the right looper and
spreader.
Left - 0,01 mm minimum, so the sewing thread goes between the right looper and spreader.
12.3. Check clearance between needle œ and support
clearance between the needle and looper carrier
12.4. Check the clearance between the needle œ and the stitching plate
12.5. The position of the left spreader
place the bracket
position at the moment when returning to buttom dead position. This adjustment affects
stretching out of the left spreader.
Revised 06/2007
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
- STANDARD MACHINE ADJUSTMENT
and right spreader Ÿ, loosen the screw
by turning the spreader rod. The right spreader must be at the home
by used thread
and adjust the stops
. Tilt the support to obtain 0,05 mm,
should be 0,2 mm, for needle Nm 100.
.
S-311
with the groove on
. The stops
and carefully
1-53