Table of Contents
Advertisement
Description
Port
Power Connect the power cord included with your gateway to this connector. Use only the power supply included with your gate-
way. Intended for indoor use only.
ETH
The yellow RJ45 port on the back of your gateway is used to connect client devices such as computers and printers to your
gateway
DSL
The grey RJ12 port labeled DSL is specifically intended for connection to an internet provider via a DSL (Digital Subscriber
Line) service.
Buttons
ON/OFF Switch
The ON/OFF toggle switch is located on the back of the gateway and turns the gateway on and off.
Reset Button
The Reset button is a small hole in the gateway's enclosure with the actual button mounted behind the surface. This style of push-
button prevents the gateway from being inadvertently reset during handling. Reset must be actuated with a paper clip or similar
implement.
The Reset button is located on the back of the unit.
This pin-hole sized reset button has three functions. The duration for which the button is held dictates which function is carried
out.
Hold Duration
Effect
Less than 6
Performs a modem reset that is equivalent to the
seconds
6-20 seconds
Performs the software equivalent to the
20 or more seconds Changes the POWER LED to red and the gateway enters CFE mode which is a state associated with performing
firmware updates via Internet browser.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
Reboot
function in the gateway software.
Restore Defaults
function in the gateway software.
6
Advertisement
Table of Contents
