Table of Contents
Advertisement
2. Enter a descriptive
Tunnel
Skip the
Mechanism
field. Currently, only the 6RD mechanism is supported.
3. Select the
WAN
and
LAN
4. Do either of the following:
a. To configure the LAN interface settings manually, enter values located below the
IPv4 Mask
l
6rd Prefix with Prefix
l
Border Relay IPv4
l
b. To configure these settings automatically, select Automatic. The fields below the buttons are hidden.
5. Click
Apply/Save
to commit your changes.
IPv4inIPv6
On this page, you can configure the IPv4inIP6 settings.
1. In the left navigation bar, click
Note: Currently, only the DS-Lite Mechanism is supported. Consult RFC6333 for further information regarding DS-Lite.
2. Enter a descriptive
Tunnel
3. Select the
LAN
and
WAN
4. Below
Associated LAN
setting automatically, select Automatic. The
5. Click
Apply/Save
to commit your changes.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
Name.
interfaces associated with the tunnel you wish to establish.
Length: Options are 0 - 32.
Length: prefix/length, such as: 2002::/64.
Address: Enter the IP address for the IPv6 relay server.
Advanced Setup
>
IP Tunnel
Name.
interfaces associated with the tunnel you wish to establish.
Interface, enter the appropriate value for
AFTR
>
IPv6inIPv4
and then click Add. The following page appears.
AFTR
(Address Family Transition Router). To configure this
field is hidden.
Manual
button.
90
Advertisement
Table of Contents
