Table of Contents
Advertisement
Field Name
Description
Remote Loopback
Click to enable on-demand link diagnostics, including bit-error-rate approximation.
Active Mode
Click to enable this feature.
Ethernet Service OAM (802.1ag/Y.1731)
WAN Interface
Select the WAN interface that you want to test.
( Appears for the 802.1ag option only ) Select the domain level for this maintenance domain.
MD Level
Options are 0 - 7 . The larger the domain, the higher the value you should select.
( Appears for the 802.1ag option only ) Enter the name of the maintenance domain, e.g., Broadcom.
MD Name
( Appears for the 802.1ag option only ) Enter the maintenance association ID, e.g., BRCM.
MA ID
( Appears for the Y.1731 option only ) Enter the level of the maintenance entity group.
MEG Level
( Appears for the Y.1731 option only ) Enter the ID of the MEG.
MEG ID
Enter the ID of the local maintenance entity group end point.. Options are 1 - 8191 . The default is
Local MEP ID
1 .
Local MEP VLAN ID
Enter the VLAN ID of the local MEP. Options are 1 - 4094 . The default is -1 (no VLAN tag).
CCM Transmission
Click to enable continuity check message transmission.
Enter the ID of the remote MEP. Options are 1 - 8191 . The default is -1 (no remote MEP).
Remote MEP ID
Loopback and Linktrace Test
Target MAC
Enter the MAC address for the test, e.g., 02:10:18:aa:bb:cc.
Enter the maximum number of hops allowed. Optinons are 1 - 233 . The default is -1 (no limit).
Linktrace TTL
Loopback Result
Displays the results of the loopback test.
Linktrace Result
Displays the results of the linktrace test.
Ping Host
On this page you can ping a server by host name or IP address.
1. In the left navigation menu, click
2. Enter the host name or IP address.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
section
section
Diagnostics Tools
>
Ping
Host. The following page appears.
104
Advertisement
Table of Contents
