Table of Contents
Advertisement
The DSCP marking QoS Queue Management Configuration marking on ingress packets is based on the selection you make in the
Default DSCP Mark
field. The selected default marking is applied automatically to all incoming packets without reference to a par-
ticular classification.
Note: A default DSCP mark value of Default(000000) will mark all egress packets that do NOT match any classification.
The following values are supported. For more information about commonly used DSCP values, refer to RFC 2475.
No Change(-1)
CS1(001000)
Auto Marking(-2)
AF23(010110)
Default(000000)
AF22(010100)
AF13(001110)
AF21(010010)
AF12(001100)
CS2(010000)
AF11(001010)
AF33(011110)
QoS Queue Config
On this page, you can configure a queue and add it to a Layer2 interface.
1. In the left navigation bar, click
page appears.
2. In the
Name
field, type a descriptive name for this queue.
3. In the
Interface
field, select the Layer 2 interface to be associated for this queue. Additional fields appear.
SmartRG Inc., an ADTRAN company. All Rights Reserved. © 2020
AF32(011100)
AF31(011010)
CS3(011000)
AF43(100110)
AF42(100100)
AF41(100010)
Advanced Setup
>
Quality Of Service
CS4(100000)
EF(101110)
CS5(101000)
CS6(110000)
CS7(111000)
>
QoS Queue Config
Select
and then click Add. The following
68
Advertisement
Table of Contents
