Disk Drive Status Lights Assembly (Model T40) - IBM 7133 D40 Service Manual

Disk Drive Status Lights Assembly (Model T40)

Step 1. If not already done, open the front cover (see "Covers" on page 138).
Step 2. Remove the front bezel assembly (see "Front Bezel Assembly (Model T40)" on
Step 3. Refer to Figure 103.
Figure 103. Removing the Disk Drive Status Lights Assembly from a Model T40
Step 4. Unscrew the screws 2 .
Step 5. Remove the disk drive status lights assembly 1 .
Step 6. Replace parts in the reverse sequence.
page 183).
1
2
Note: Ensure that the latches of the operator panel flexible circuit and the disk
drive status lights flexible circuit engage fully in the slots of the 7133
frame assembly.
2
Chapter 3. Removal and Replacement Procedures
189