Table of Contents
Advertisement
Step 6. Refer to Figure 126.
2
Figure 126. Removing the Frame from a Model T40 (2)
Step 7. At the back of the 7133, remove the two screws 1 .
Step 8. Remove the equivalent two screws from the bottom of the frame assembly.
Step 9. Pull out the shim 2 .
Step 10. Go to the front of the 7133.
Step 11. Note: For a translation of the following notice, see the 7133 Serial Disk
Systems and SSA Adapters: Translated Safety Notices manual.
CAUTION:
Do not attempt to lift the 7133 by yourself. Ask another service
representative for aid.
With aid from another service representative, pull the frame assembly forward
and remove it from the deskside unit.
Step 12. Replace parts in the reverse sequence.
Notes:
a. When you install the frame assembly :
1) Ensure that you reinstall the RFI bracket at the front of the 7133 when
you reinstall the front bezel assembly. The RFI bracket prevents radio
1
Chapter 3. Removal and Replacement Procedures
219
Advertisement
Table of Contents
