Table of Contents
Advertisement
Step 4. Refer to Figure 133.
Figure 133. Removing the Front Screws
Step 5. Attention: To prevent damage to the flexible circuits, disconnect them before
Step 6. Do the same actions with the latch 1 to unplug the disk drive status lights
230
7133 Models D40 and T40 Service Guide
you remove the front mounting screws.
If a latch retainer 3 is present, remove the two screws 4 and the latch
retainer.
Move the latch 2 to your left, then pull it forward to unplug the operator panel
flexible circuit from the controller card assembly.
flexible circuit from the controller card assembly.
Advertisement
Table of Contents
