Model D40 In A Netfinity Rack - IBM 7133 D40 Service Manual

Model D40 in a Netfinity Rack

Step 1. Note: For a translation of the following notice, see the 7133 Serial Disk
Figure 132. Removing the Back Brackets
Step 2. At the back of the rack, remove the screws 1 and 6 and the washers 2
Step 3. Remove the two back brackets 3 and 4 .
Systems and SSA Adapters: Translated Safety Notices manual.
CAUTION:
The stabilizer must be correctly attached to the bottom front of the rack,
or the rack must be firmly fastened to the floor, to prevent the rack from
tipping forward while the 7133 is being installed into the rack. Do not
install or pull out any unit unless either the stabilizer is firmly attached to
the rack, or the rack is firmly fastened to the floor, as described in the
rack installation instructions.
Refer to Figure 132.
and 5 .
Chapter 3. Removal and Replacement Procedures
229