Model D40 In An Rs/6000 Rack - IBM 7133 D40 Service Manual

Model D40 in an RS/6000 Rack

Step 1. Note: For a translation of the following notice, see the 7133 Serial Disk
Figure 127. Clamp Plates and Brackets
Step 2. If the back of the 7133 is fastened with clamp plates 1 , go to step 3 on
Systems and SSA Adapters: Translated Safety Notices manual.
CAUTION:
v The stabilizer must be correctly attached to the bottom front of the
rack, or the rack must be firmly fastened to the floor, to prevent the
rack from tipping forward while the 7133 is being installed into the
rack. Do not install or pull out any unit unless either the stabilizer is
firmly attached to the rack, or the rack is firmly fastened to the floor,
as described in the rack installation instructions.
v If the 7133 is installed in a Model T00 or T42 rack, you must also
observe the safety notices for those racks before you start to remove
the 7133. You can find the safety notices in the System Installation
chapter of the 7014 Model T00 and T42 Rack Installation and Service
Guide, SA33-0577, or at web page:
http://www.rs6000.ibm.com/resource/hardware_docs/sa38-0577/a4aw9bas.html
Refer to Figure 127.
page 224.
If the back of the 7133 is fastened with brackets 2 , go to step 6 on
page 225.
Chapter 3. Removal and Replacement Procedures
223