IBM 7133 D40 Service Manual page 102

Serial disk systems
Hide thumbs Also See for 7133 D40:
Table of Contents

Advertisement

SRN
FRU List
D0102
None
D0103
None
D0200
Disk drive module (100%) ("Disk Drive
Modules and Dummy Disk Drive
Modules" on page 150).
D0300
Disk drive module (100%) ("Disk Drive
Modules and Dummy Disk Drive
Modules" on page 150).
D0400
Disk drive module (100%) ("Disk Drive
Modules and Dummy Disk Drive
Modules" on page 150).
D0450
None
D0460
None
D4000
Not applicable
to
D6PAA
84
7133 Models D40 and T40 Service Guide
Problem
Description: The command line diagnostics have detected
that the device is reserved or fenced out.
Action: Use the -u flag to break the reservation or fence.
Warning: If another using system is using this device,
unpredictable results might occur if you break the
reservation or fence.
Description: The diagnostics attempted to break a
reservation, but this adapter does not provide support for
the function.
Action: A different adapter is using the disk drive module.
Release the disk drive module, and run the diagnostics
again.
Description: The disk drive module timed out while the
diagnostics were running.
Action: Rerun the diagnostics. If the problem remains,
exchange the FRU for a new FRU.
Description: The disk drive module failed the diagnostic test.
Action: Exchange the FRU for a new FRU.
Description: The disk drive module is not ready while the
diagnostics are running.
Action: Rerun the diagnostics. If the problem remains,
exchange the FRU for a new FRU.
Description: A Format operation is in progress.
Action: The Format operation that was started on this disk
drive module has not yet finished.
A Format operation can take up to 30 minutes to run. Wait
for it to finish before you run the diagnostics again. You can
observe the progress of the Format operation by running the
Format service aid again on this disk drive module.
Description: A Format operation has been degraded.
Action: The Format operation that was started on this disk
drive module did not finish. Possibly, the disk drive module
was switched off while the Format operation was running.
Run the Format service aid to format this disk drive module.
Description: SRNs in this range are not enclosure
(subsystem) SRNs.
Action: For SRNs in this range, see the documentation for
your SSA attachment.

Advertisement

Table of Contents
loading

This manual is also suitable for:

7133 t40

Table of Contents