Table of Contents
Advertisement
Step 26. If you are exchanging the bezel assembly, you must install the later-type
bezel and the later-type power switch and cable assembly. Go to "Converting
from Early- to Later-Type Bezel Assembly and Power Switch and Cable
Assembly" on page 195.
If you are reinstalling the original bezel, replace parts in the reverse
sequence.
Notes:
a. Reconnect the operator panel flexible circuit and the disk drive status
lights flexible circuit to the controller card before you reinstall the RFI
bracket.
b. Ensure that the latches of the operator panel flexible circuit and the disk
drive status lights flexible circuit engage fully in the slots of the 7133
frame assembly.
c. Do not forget to reinstall the RFI bracket. This bracket prevents radio
frequency interference.
d. When connecting the power cable assembly to the bezel assembly,
carefully align the two connectors, then press in the cable strongly until
you hear a click.
Chapter 3. Removal and Replacement Procedures
187
Advertisement
Table of Contents
