Table of Contents
Advertisement
Step 8. Refer to Figure 91.
1
Figure 91. Installing the Cables
Step 9. Install the power cable 1 and, if present, the 7133 power-control cable 2 .
Notes:
a. When present, the 7133 power-control cable is plugged into the power
supply assembly that is in position 1 (see "Parts Locations" on page 17).
b. On a −48 volt 7133 Model D40, ensure that one power supply assembly is
connected to power source A in the rack, and that the other is connected
to power source B (see the 7133 Model D40 Serial Disk System:
Installation Guide for details).
2
Chapter 3. Removal and Replacement Procedures
171
Advertisement
Table of Contents
