Table of Contents
Advertisement
Step 6. Refer to Figure 117.
2
Figure 117. Removing the Remote-Power-On Control Unit from its Bracket
Step 7. Remove the two nuts 1 and their lock washers.
Step 8. Remove the remote-power-on control unit 2 from the bracket.
Step 9. Replace parts in the reverse sequence.
Note: If the 7133 remained operational while you removed the
remote-power-on control unit, ensure that the power switch of the
remote-power-on control unit that you are going to install is set to | (on)
before you reinstall any power-control cables. Otherwise, when you
install the cables, the internal dc power of the 7133 might switch off.
1
1
Chapter 3. Removal and Replacement Procedures
207
Advertisement
Table of Contents
