Table of Contents
Advertisement
DRPC-240-TGL Embedded System
Figure 3-6: Wi-Fi Module Installation
3.8 PoE Power Module Installation (Optional)
This PoE power module provides PoE function to the 4 LAN ports of the DRPC-240 to offer
a maximum power consumption of 60W, and a single port power consumption of 15W. To
install the PoE module, follow the steps below.
Step 1:
Align the PoE power module (GPOE-DRPC-240-R10) with the 4 studs and 2
pin headers, and install them in place after positioning.
Step 2:
Secure the PoE power module with four retention screws.
Step 3:
The PoE power module comes with a heat sink, so you need to uncover the
opening reserved for the heat sink before re-installing the back cover. Remove
the two retention screws to uncover the opening on the back cover, and then re-
install the back cover using 6 retention screws (Figure 3-7).
Page 31
Advertisement
Table of Contents
