Table of Contents
Advertisement
3.5 Memory Installation
The DRPC-240-TGL is pre-installed with an 8GB memory module. Users can add or
replace memory with different capacity by themselves, the installation procedures are
described below.
Step 1:
Open the two handles of the memory slot.
Step 2:
Remove the old memory module and insert a new memory module. Carefully
align the memory module so the notch on the memory lines up with the notch
on the memory socket.
Step 3:
Once aligned, press down until the memory module is properly seated and the
two handles fully clip into place (Figure 3-3).
Figure 3-3: Memory Installation
3.6 Storage Installation
The DRPC-240-TGL supports two types of storage, one M.2 B Key & one 2.5" SSD. Before
installing a M.2 SSD or 2.5" SSD/HDD, please follow the steps described in Section 3.4 to
remove the HDD bracket.
Page 28
DRPC-240-TGL Embedded System
Advertisement
Table of Contents
