Table of Contents
Advertisement
DRPC-240-TGL Embedded System
Figure 3-8: External Fan Module Installation
3.10 Adding External I/O Ports (Optional)
Additional two external I/O ports can be added on the DRPC-240-TGL, such as DIO. To
do this, follow the steps below.
Step 1:
Connect one end of the I/O cable to the pin headers on the motherboard
Step 2:
Remove the DB9 knockout reserved on the chassis. Secure the other end of
the cable to the knockout hole (Figure 3-9).
Figure 3-9: I/O Cable Installation
Page 33
Advertisement
Table of Contents
