Table of Contents
Advertisement
DRPC-240-TGL Embedded System
2.1 Unpacking
To unpack the embedded system, follow the steps below:
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the system out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the system.
Step 7:
Make sure all the components listed in the packing list are present.
2.2 Packing List
NOTE:
If some of the components listed in the checklist below are missing,
please do not proceed with the installation. Contact the IEI reseller or
vendor you purchased the DRPC-240-TGL from or contact an IEI sales
representative directly. To contact an IEI sales representative, please
send an email to sales@ieiworld.com.
The DRPC-240-TGL is shipped with the following components:
Step 0:
Page 21
Advertisement
Table of Contents
