Table of Contents
Advertisement
DRPC-240-TGL Embedded System
Figure 3-14: RJ-45 Ethernet Connector
The RJ-45 Ethernet connector has two status LEDs, one green and one yellow. The green
LED indicates activity on the port and the yellow LED indicates the port is linked.
See Table 3-1.
Activity/Link LED
STATUS
DESCRIPTION
Off
No link
SSYellow
Linked
Blinking
TX/RX activity
Table 3-1: RJ-45 Ethernet Connector LEDs
USB Device Connection
The DRPC-240-TGL has two USB 3.2 and two USB 2.0 ports. To connect a USB device,
please follow the instructions below.
Step 1:
Located the USB connectors. The locations of the USB connectors are
shown in Chapter 1.
Step 2:
Align the connectors. Align the USB device connector with one of the
connectors on the I/O panel. See Figure 3-15.
Step 3:
Insert the device connector. Once aligned, gently insert the USB device
connector into the onboard connector.
Speed LED
STATUS
DESCRIPTION
Off
100 Mbps connection
Orange
1 Gbp connection
Green
2.5 Gbps connection
Page 37
Advertisement
Table of Contents
