Powering On/Off The System; Power Input & Led; Figure 3-21: Power Button - IEI Technology DRPC-240-TGL User Manual

DRPC-240-TGL Embedded System

3.14 Powering On/Off the System

WARNING:
Make sure a power supply with the correct input voltage is being fed into the
system. Incorrect voltages applied to the system may cause damage to the
internal electronic components and may also cause injury to the user.
 Power on the system: press the power button for 3 seconds
Power off the system: press the power button for 6 seconds

 The power of this system can be less than 250w-20A.

Figure 3-21: Power Button

3.15 Power Input & LED
There is a power connector on the panel. The power connector is a 3-pin terminal block.
Supported power input voltage: 12-28V.
Page 41