Leckey BeMe User Manual page 18

p18 Leckey BeMe User Manual
When not in use, ensure the push button
control handset is stowed on the chassis as
shown :
Before the product is used for the first time it
is recommended that the battery should be
fully charged for 12 hours. To do this, plug the
supplied charger into the side of the battery
pack , and plug into a wall AC supply. The
charger will show a light to indicate its status
• Green: Plugged into mains;
• Yellow: Charging;
• Back to Green: when the battery is fully
charged.
When charged, switch off the wall AC supply,
remove the adaptor plug and disconnect the
lead from the battery. Ensure to disconnect
the battery charger from the battery before
moving the seat. The battery charge should
be topped up each day for approximately
one hour. The electrical seat height
adjustment can be operated whilst the battery
is on charge.
Before operation, ensure that the cable to
the hand controller is not caught or wrapped
around any of the chassis parts.
When operating, ensure that neither you nor
any child at floor level has got their fingers in
the way of the seat lifting arm.
Ensure the battery charger is disconnected
from the battery before moving the seat.
Battery duty cycle: 2 minutes of operation
in 20 minutes (i.e., leave the battery to cool
down for 18 minutes if operated for 2 minutes
continuously).
The electrical items are rated IP51 and are not
waterproof. Only clean with a damp cloth and
do not clean with running water as water may
enter the cable connections.
If taking the product out of a cold storeroom,
allow 2 hours for it to come to room
temperature and wipe it down to remove any
condensed moisture before operation.