Advertisement

My independence.
My freedom.
My choice.
My movement.
MyWay!
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MyWay and is the answer not in the manual?

Questions and answers

Kathy
March 17, 2025

How to adjust red and white straps

1 comments:
Mr. Anderson
March 17, 2025

To adjust the red and white straps on the Leckey MyWay:

1. Connect the white clips on the harness connection point straps to the white buckles on the harness (both sides).
2. Connect the red clips on the harness connection point straps to the red buckles on the harness (both sides).
3. Once all four straps and buckles are connected, pull the pulley straps to adjust the user’s position, bringing them closer to the frame if needed.
4. Ensure the harness connection point straps are taut. If they feel slack, pull the pulley straps further to tighten.

Warning: Ensure all four straps and buckles on the upper support unit and harness are properly connected.

This answer is automatically generated

Summary of Contents for Leckey MyWay

  • Page 1 My independence. My freedom. My choice. My movement. MyWay! User Manual...
  • Page 2 This manual shows you how you can quickly and easily make use of all of MyWay’s functions. • Saddle The instructions on the safety and maintenance of the product will ensure that you will enjoy the use of this product for a long time.
  • Page 3: Table Of Contents

    MyWay User Manual Contents 1. Intended Use p.04 2. Declaration of Conformity p.04 3. Terms of Warranty p.05 4. Product History Record p.05 5. Product Training Record p.05 6. Safety p.06 7. Contra-indications / Cautions p.07 8. Main Frame Set-Up / Features p.08...
  • Page 4: Intended Use

    2.0 Declaration of Conformity James Leckey Design Ltd as manufacturer with sole responsibility declares that the Leckey MyWay conforms to the requirements of the 93/42/EEC Guidelines, Medical Device Regulations 2002 and EN 12182 Technical aids for disabled persons and test methods.
  • Page 5: Terms Of Warranty

    Leckey manufactured products and components. 4.0 Product History Record Your Leckey product is classified as a Class 1 Medical Device and as such should only be pre- scribed, set up or reissued by a technically competent person who has been trained in the use of this product.
  • Page 6: Safety

    Leckey equipment. secure at all times. • The product should be • Only use Leckey approved stored carefully and not • Clean the product components with your used if any parts are faulty.
  • Page 7: Contra-Indications/Cautions

    MyWay User Manual 7.0 Contra-indications/Cautions Contra-indications Cautions • Children with significant • Children with severe leg length discrepancy dystonic movement which precludes from which presents a manual reciprocal contact with handling risk for child and the floor when stepping. carer when getting the child in and out of the •...
  • Page 8: Main Frame Set-Up/Features

    MyWay User Manual 8.0 Main Frame Set-Up/Features 8.1 Frame | Unfolding the Frame • Lift the frame out of the box and set it on a flat, stable surface, keeping it in the same position as it was packaged within the box i.e.
  • Page 9 MyWay User Manual Warning – to check if frame legs are fully locked out, lift the frame in an upwards direction - if the legs do not sway/drop etc., the frame and legs are in the correct position. If the legs do sway/drop you must reposition the legs.
  • Page 10 MyWay User Manual 8.3 Upper Support Unit | Handling the Upper Support Unit Note – this section only applies to sizes 2 and 3 as the upper • Ensure overall height is support unit does not detach from size 1.
  • Page 11 MyWay User Manual 8.5 Upper Support Unit | Detaching the Upper Support Unit from the Frame • Ensure overall height is adjusted to its highest Warning – do not attempt to detach the upper support position - see section 8.12 unit whilst the user is in the product.
  • Page 12 MyWay User Manual 8.6 Castors | Applying/Releasing Brakes • To apply the brakes, place foot on the brake pedal. Push the brake pedal once until a click is heard, then press once again. • To release the brakes, tap...
  • Page 13 MyWay User Manual 8.8 Castors | Anti-Roll Back Feature • Ensure the directional lock feature has been applied to both rear castors – see section 8.7 ‘Direction lock feature’ for details. • To apply anti-roll back, push the knob towards the one directional arrow icon as far as it will go.
  • Page 14 MyWay User Manual 8.10 Upper Support Unit Adjustments | Prone Angle • To increase prone angle, turn the knob in an anti-clockwise direction. Up to 10˚ of angle adjustment can be achieved. • To decrease prone angle, turn the knob in a clockwise direction.
  • Page 15 MyWay User Manual 8.12 Upper Support Unit Adjustments | Overall Height Adjustment • Overall height is adjusted by pressing the button Note – in order to operate and then the lever. the overall height adjustment, If the button is not...
  • Page 16 MyWay User Manual 8.13 Upper Support Unit Adjustments | Adjustment of the Harness Connection Points • Once the child is in the frame and the harness has been attached to the upper support unit by the buckles (see section 9.5 ‘Attaching the harness to the frame’),...
  • Page 17 MyWay User Manual 8.14 Upper Support Unit Adjustments | Shoulder Height Adjustment • Flip the grey lever up slide the shoulder unit up/ down until the desired position is achieved. • Once the shoulder unit is in the desired position, flip the...
  • Page 18: Harness Set-Up/Features

    MyWay User Manual 9.0 Harness Set-Up/Features Warning – a risk assessment should be carried out to ensure that the correct size of harness is used. 9.1 Preparing the Harness • Lie the harness out flat (with coloured buckles facing upwards) on a flat surface e.g.
  • Page 19 MyWay User Manual 9.2 Donning the Harness | In Lying • Position the user on a plinth in a side lying position. • Place the harness under the user using a rolling technique, with the lower edge of the harness just over the top of the pelvis (by about 2-3cm).
  • Page 20 MyWay User Manual 9.3 Donning the Harness | In Supported Standing Warning – Donning the harness in supported standing may only be possible if the user can take their own weight through their legs. • Sit the user on a chair,...
  • Page 21 MyWay User Manual 9.4 Transferring the harness to/out of the frame Warning – When transferring the user to/from the device, normal moving and handling procedures should be adhered to. Two carers are required for transfers. Standing Transfer to the Frame: •...
  • Page 22 MyWay User Manual • Release the grey • Release the black • Open the striped belt strap shoulder strap buckles groin strap buckles and harness wrap. on the harness. on the harness. • Assist the user to step away from the harness and frame.
  • Page 23 MyWay User Manual Hoisting Transfer to the Frame: Hoist Points Hoist Points • Position the user in lying or perched sitting with support on the edge of a plinth. • Attach the hoist straps to the harness using the two...
  • Page 24 MyWay User Manual Hoisting Transfer out of the Frame: • Attach the hoisting straps to the harness- see section 10.6 ‘Hoisting Straps’ for instructions- and connect the straps to the hoist. • Raise the hoist until the hoisting straps are taut.
  • Page 25 MyWay User Manual 9.5 Attaching the Harness to the Frame • Ensure the harness connection point straps have been adjusted as per instructions in section 8.13 ‘Adjustment of the Harness Warning – If necessary, ensure the user is supported whilst buckles are fastened either by attaching and using the Connection Points’.
  • Page 26 MyWay User Manual • Adjust the shoulder height, as per instructions in section 8.14 ‘Shoulder Height Adjustment’. The top of the shoulder straps should be level with the user’s shoulders. • Place the shoulder straps over the user’s chest and connect...
  • Page 27 MyWay User Manual 9.6 Detaching the harness from the frame • Ensure the frame brakes have been applied- see section 8.6 ‘Applying/ releasing brakes’ for instructions • Disconnect the grey clips on the shoulder straps from the grey buckles on the harness.
  • Page 28: Accessories Set-Up/Features

    MyWay User Manual 10.0 Accessories Set-Up/Features 10.1 Adult Handles • To attach the adult handles, feed the handles into the attachment metalwork situated on the device’s frame and slide upwards. • There are two knobs on cords attached to...
  • Page 29 MyWay User Manual Warning – be aware of finger placement when attaching/ detaching the adult handles to avoid potential for finger nipping. The adult handles should not be used to lift the device. Be aware of others within the environment where the device is being used and avoid the adult handles making contact with them.
  • Page 30 MyWay User Manual 10.3 Headrest • To attach the headrest, flip up the rubber cap situated on the top of the upper support unit to expose the headrest receiver slot. • Insert the headrest attachment pole into the receiver slot, then turn the handle in a clockwise direction.
  • Page 31 MyWay User Manual 10.4 User Handles • To attach the user handles, • To detach the user handles, slide the handle into the press the silver popper and receiver tube and feed it slide the handle out in a upwards.
  • Page 32 MyWay User Manual 10.5 Ankle Guides • To attach the ankle guides, feed the cord loop over the front castor, hooking it into the crevice between the castor and the frame tube. • At the opposite end of the...
  • Page 33 MyWay User Manual • To adjust the sliders, slacken the ankle guide cord by loosening the knob at the end of the frame tube ; unclip the sliders and move them to the desired positions ; clip the sliders over the ankle...
  • Page 34 MyWay User Manual 10.6 Hoisting Straps • To attach the hoist straps, start with one side of the harness e.g. the left hand side. Attach one carabiner to the front loop on the harness, then attach the second carabiner to the corresponding back loop.
  • Page 35 MyWay User Manual 10.7 Saddle • The saddle attaches into the plastic moulding. • Firstly, feed the pulley straps through the saddle. If this is not done the straps will cause an obstruction. • Move the saddle upwards so it is in a vertical position and hook the saddle bar into the plastic moulding.
  • Page 36: Typical Set-Up Order

    10.7 ‘Saddle’ for by standing the user and These are a useful adjunct full instructions. moving to either side to to MyWay to enable carers achieve mobile weight • Headrest: If the user has to safely push and steer bearing/lateral shift.
  • Page 37 MyWay User Manual 11.3 Harness preparation 11.4 Transfer to Frame 11.5 Shoulder height and don and supports • See sections 9.1 ‘Preparing • See section 9.4 • See section 8.14 the harness’ and 9.2 ‘Transferring the harness ‘Shoulder Height ‘Donning the harness’...
  • Page 38: Cleaning And Care Information

    MyWay User Manual 12.0 Cleaning and Care Information Harness • The harness can be 4) Fold the harness inwards, Microfibre consists of very machine washed at so the coloured inside is fine threads of polyester and 40°C on a gentle program.
  • Page 39: Daily Product Inspection

    Warning – If in any doubt • Make sure the product to the continued safe use is dry before use. of your Leckey product or if any parts should fail, please cease using the product and contact our Customer Care team or your local dealer as soon as possible.
  • Page 40: Annual Product Inspection

    Leckey product or if 6. Check the user’s harness product is reissued for use. any parts should fail, please...
  • Page 41: Reissuing Leckey Products

    12 ‘Cleaning and Care Warning – If in any doubt to the continued safe use Information’ of this manual. of your Leckey product or if any parts should fail, please cease using the product and contact our Customer Care team or your local dealer as soon as possible.
  • Page 42: Technical Information

    MyWay User Manual 17.0 Technical Information Size 1 Frame Size 2 Frame Size 3 Frame Age (approx.) 9-16 User Shoulder Height (to floor) (mm) 635 – 920 870-1190 1070 – 1490 User Saddle Height (inside leg) (mm) 220 – 440...
  • Page 43: Product And Accessory Codes

    173-1600 Size 1 MyWay Frame 173-2600 Size 2 MyWay Frame 173-3600 Size 3 MyWay Frame 173-4100-04 Size 1 Purple MyWay Harness 173-4200-07 Size 2 Green MyWay Harness 173-4300-02 Size 3 Blue MyWay Harness 173-4400-09 Size 4 Red MyWay Harness 173-4500-06...
  • Page 44 Leckey 19C Ballinderry Road Lisburn BT28 2SA Northern Ireland United Kingdom T: 028 9260 0750 F: 028 9260 0799 E: info@leckey.com W: www.leckey.com LS900-01...

Table of Contents