Leckey BeMe User Manual page 101

To achieve maximum range of seat depth, the
front section should be orientated as shown
above. To achieve minimum range of seat
depth, remove the bolts
the seat, and rotate the front section so that
the short edge faces upwards
the front section so that the slider
E
, are reengaged on either side. Reattach
the bolt with washer at either side of the seat,
adjust to the desired position and tighten the
bolts to secure in place.
Reset the front base foam piece
it rests up against the front inside surface of
the platework. Set the front contoured foam
piece , into position, aligning the foam with
the front of the platework.
F
, at either side of
. Reattach
, and slot,
E
F
, so that
Leckey BeMe User Manual p101
You can also adjust the depth of the base
plate to prevent overhang of the contoured
seat plate. To adjust the seat depth on the seat
plate, loosen the left and right bolts on the
underside of the seat base and move forward
and backward to a suitable position. Tighten
both bolts to secure in place (see 18.1 or 18.2
for pictures).