Installation Environmental
Considerations
The instrument is designed for general-duty, indoor
installations. The electronics enclosure environmental rating is
NEMA 12 and the Fluidics enclosure is a NEMA 4X fiberglass
with a clear door window.
The Orion 2210AM Ammonia Analyzer should be installed in a
well-ventilated location, with ambient temperature between
5°C and 45°C (41°F to 113°F); and relative humidity not to
exceed 90% at 40°C. The area must be free from dust,
corrosive gases, vibration and shocks; sheltered from direct
sunlight, and shielded from dripping water. Power should be
instrument grade with over voltage protection, and a provision
for disconnecting power.
Mounting the Instrument
The instrument case is designed for wall or panel mounting.
Use four #10 screws or equivalent for proper support.
Refer to Figure 3 and Figure 4 for dimensions (in mm and
inches).
Make sure that the wall that you choose can support the
weight of the instrument (approximately 20 kg or 44 lbs.)
(See Figure 3).
Locate the instrument as close to the sampling point as
practical to ensure complete purging of the sample line
during each cycle.
Allow approximately 50 cm (20 in.) of clearance at the left
side for door swing. Also allow enough clearance on the
right side for wiring conduit.
Locate the analyzer height such that the display is at
eye-level height for an operator, allowing also for
appropriate sample and drain connections.
Orion 2210AM Ammonia Analyzer
Figure 3. Mounting dimensions
Installation Environmental Considerations
|
9