Autosampler Use; Introduction; Autosampler Installation; Autosampler Set-Up - Thermo Scientific iCAP 6000 Series Maintenance Manual

iCAP Customer Training Manual

3 Autosampler Use

3.1 Introduction

The autosampler can be configured to suit an application, or several applications.
The volume, number and type of sample will all influence the set-up of the autosampler.

3.2 Autosampler Installation

To comply with safety and warranty requirements the iCAP 6000, accessories and associated
equipment must be installed by a Thermo Fisher trained and certified engineer.

3.3 Autosampler Set-up

Figure 37 Autosampler Tubing Set-up
For analysis with an autosampler the capillary tubing attached to the end of the autosampler
probe should be attached to the end of the sample pump tubing on the iCAP 6000. To minimise
the sample volume required the length of the capillary tubing should be minimised, but should
allow free movement over the whole sample area of the autosampler.
.
.