Table of Contents
Advertisement
Menu Overview
Explanations of the four major menu sections are described
as follows:
Setup - For configuring the instrument's functionality and
operational parameters, such as measurement range,
measurement frequency, display contrast, date, time, and
more.
Measurement - For performing the manual analysis,
calibration, validation and cleaning cycles.
View Data and Alarms - For reviewing the collected data of
up to the last 31 days in text and graphics mode, and for
reviewing and resetting the various Alarms and Faults
triggered during the latest cycle performed.
Services - For system administration, hardware setup, prime
fluidics and diagnostics; and control of the various devices
including LED, pumps, input level sensors, relays and analog
outputs.
Press the STOP key to exit Auto RUN
NOTE:
mode to access the Service Menu.
Setup Menu
Alarms Menu
Allows configuration of alarm parameters (type, value and
hysteresis). Also allows assignment of individual alarms to
faults.
Relays Mapping Menu
Allows mapping of multiple alarms to individual relays.
Analog Outputs Menu
Allows configuration of individual analog outputs.
Inputs Menu
Allows configuration of five internal inputs (for fluidics sensors)
and two external inputs (for instrument control).
Display Parameters Menu
Allows configuration of display-related parameters.
26 |
Menu Overview
Calibration Parameters Menu
Allows configuration of parameters for calibration. The menu
shows two columns tagged as REFERENCE and CURRENT.
The parameters listed under the REFERENCE column are
set for validating auto calibrations repeats. The new calibra-
tion results are tested against the reference calibration param-
eters listed under the REFERENCE column. The CURRENT
column shows the current operating parameters that are
being used by the instrument when calculating the analysis
measurement result. Calibrations are similar to analysis cycles
and are on the method set in METHOD PARAMETERS menu.
Validation Parameters Menu
Allows configuration of parameters for validation, choice of
validation source, and repetitions required.
Analysis Parameters Menu
Allows configuration of parameters for instrument mode,
measurement frequency, measurement units, analysis label,
cell wash and reagent flow rates, stability criteria and post
wash events. Separate post wash events can be
programmed for analysis, calibration, and validation cycles.
Cleaner Parameters Menu
Allows configuration of the parameters for manual or periodic
cleaning of the reaction cell.
Temperature Units Menu
Allows selection of units for displaying the temperature
readings. Choice of Fahrenheit (°F) or Celsius (°C).
Method Parameters Menu
Allows configuration of the parameters for method and order
of the events for analysis and calibration. Consult factory
before modifying any parameter.
Date and Time Menu
Allows configuration of the date and time format and editing of
the current date.
Daylight Saving
Allows configuration of the daylight saving for USA, Europe
and custom settings. When daylight saving is enabled, the
system will correct the time based on the settings shown
below the selection.
Orion 2210AM Ammonia Analyzer
Advertisement
Table of Contents
