Configuration -Config Mode - Sokkia 130R Series Operator's Manual

Prism constant correction
Reflective prisms each have their prism constant.
Set the prism constant correction value of the reflective prism you are using.
When selecting "None (Reflectorless)" in "Reflector", prism constant
correction value is set to "0" automatically.
• The following are samples of the prism constant correction values of
reflective prisms from Sokkia.
25.2

Configuration -Config Mode-

The following explains the Config Mode.
Press {CNFG} in any screen, except during operation, to start Config Mode.
Config
Obs.condition
Instr.config
Instr.const
Comms setup
Unit
Observation Condition
Select "Obs. condition" in Config mode
Items set and options (*: Factory setting)
Dist mode
Tilt crn (Tilt angle
compensation)
coll. crn (Collimation
correction)
AP01 (Constant = 40mm)
Correction Value = -40
)
:
:
Sdist*, Hdist, Vdist
Yes(H,V)*, Yes(V), No
Yes*, No
25. CHANGING THE SETTINGS
C h a n g e P a s s w o r d
D a t e a n d Ti m e
:
:
D i s t . r e s o
: 1 m m
1
121