Power On - Sokkia 130R Series Operator's Manual

9. POWER ON

Setting "V manual": "25.2 Configuration -Config Mode-" , Setting / changing
password: "25.4 Changing Password"
PROCEDURE
1. Power on
Press {ON}.
When the power is switched on, a
self-check is run to make sure the
instrument is operating normally.
• When password id set, the
display appears as at right. Input
password and press {
• When "V manual" is set to "Yes",
the display appears as at right.
Manually indexing the vertical
circle by face left, face right
measurements:
"34. EXPLANATION"
After that, Meas Mode screen
appears.
If "Out of range" is displayed, the
instrument tilt sensor is indicating
that the instrument is out of level.
Level the instrument once again
and the horizontal and vertical
angles will be displayed.
• When "Resume" in "Instr. config" is set to "On", the screen previous to power off
is displayed.
"25.2 Configuration -Config Mode-"
• "Tilt crn" in "Obs. condition" should be set to "No" if the display is unsteady due
to vibration or strong wind.
"25.2 Configuration -Config Mode-"
30
}.
P a s s w o r d :
A