13. RESECTION MEASUREMENT
6. Press [CALC] or [YES] to
automatically start calculations
after observations of all known
points are completed. Instrument
station elevation and standard
deviation, which describes the
measurement accuracy, are
displayed.
7. Press [RESULT] to check the
result.
If there are no problems in the
result, press {ESCAPE} and go to
step 10.
8. If there are problems with the
results of a point, align the cursor
with that point and press [BAD].
"*" is displayed on the left of the
point.
9. Press [RE CALC] to perform
calculation again without the point
designated in step 8. The result is
displayed.
If there are no problems with the
result, go to step 10.
If problems with the result occur
again, perform the resection
measurement from step 3.
10. Press [OK] to finish resection
measurement. Only Z (elevation)
of the instrument station
coordinate is set. N and E values
are not overwritten.
54
1 0 . 0 0 0
Z
Z
0 . 0 0 2 2 m
R E S U LT
Z
- 0 . 0 0 3
1 s t
- 0 . 0 0 3
2 n d
0 . 0 0 0
3 r d
0 . 0 0 2
4 t h
B A D
RE_CALC
R E C
O K
RE_OBS
A D D