Sokkia 130R Series Operator's Manual page 67

5. Press [ S-O] to select distance
input mode.
Each time [ S-O] is pressed: S-O
S (slope distance) , S-O H
(horizontal distance), S-O V
(height difference), S-O Coord
(coordinates), S-O Ht. (REM
measurement).
"14.2 Coordinates Setting-out
Measurement", "14.3 REM
Setting-out Measurement"
• When [READ] is pressed,
registered coordinates can be
recalled and used. Distance and
angle are calculated using the
coordinate value.
"12.1 Entering Instrument
Station Data, PROCEDURE
Reading in Registered
Coordinate Data"
6. Set the following items.
(1) Sdist/Hdist/Vdist: distance
from the instrument station to
the position to be set out.
(2) H ang: included angle
between the direction of the
reference and the point to be
set out.
• Pressing [COORD] in the
second page allows you to enter
the coordinates of the point to be
set out.
7. Press [OK] to set the input values.
8. Rotate the top of the instrument
until "dHA" is 0° and place the
target on the sight line.
14. SETTING-OUT MEASUREMENT
S
S d i s t :
H a n g :
READ
H
H
H
S-O
READ
H
H
H
0 . 0 0 0 m
O K
4 0 0 0 0 0
OK
59