GE Venue Fit Technical Publication page 248

P R E L I M I N A R Y
DIRECTION 5854713-100, REVISION 2
3.) Connect the wireless adapter box to the printer using 2 USB cables supplied with the kit.
4.) Verify that the switch on the wireless adapter box is set to RUN position.
5.) Connect the power cable to the printer and then to the wall power outlet.
6.) Turn On the Printer.
7.) On the Application screen, open Settings->Config -> Connectivity -> Additional Outputs.
8.) Make sure that under the 'Sent To Setup' field, the Sony UP-898 series is selected.
9.) Tap Properties is needed to setup the paper size..
Perform the Functional checks listed in
8-38
Table 4-3-5-1
Chapter 8 - Replacement Procedures
VENUE FIT™ SERVICE MANUAL
- Printer Checks section