MacDon M1170 Unloading And Assembly Instructions page 45

NOTE:
When all three sets of weights are installed, no spacers are
required.
13. Bring left bezel (A) close to the frame. Connect plug P215 to
the back of red tail/brake light (E).
14. Loosely secure left bezel (A) to the frame with four hex
flange bolts (B).
15. Repeat Step 12, page 37
16. Attach plug P210 to right bezel (C).
17. Turn the IGNITION key to the RUN position. Ensure that
rear swath lights (D) and red tail/brake lights (E) are
working. If they are not working, determine the source of
the fault and correct it.
18. Tighten hex flange bolts (B) to secure the left and right light
bezels.
IMPORTANT:
Ensure that rear swath lights (D) are centered in the
light bezel.
215981
ASSEMBLING WINDROWER
and Step 13, page 37.
F
D
C
Figure 3.46: Two Ballast Kits Installed – 326 kg
(720 lb.)
F
D
C
Figure 3.47: Three Ballast Kits Installed – 489 kg
(1080 lb.)
B
E
Figure 3.48: Rear Light Bezel with Ballast Kit(s)
Installed
37
F
B
E
F
B
A
C
A
Revision A
A
D