MacDon M1170 Unloading And Assembly Instructions page 44

8. Retain center portion (A) of the light bezel assembly for
reinstallation. Install six hex screws (B) on the side bezels.
NOTE:
These hex screws will be used when reinstalling the center
portion of light bezel.
CAUTION
Keep your fingers clear of the weight bracket.
9. Install weights (A) from the outboard side of the windrower.
Slide the weights to the middle of the bracket on the
walking beam.
10. Install retaining bracket (B) on each side of the weight
bundle.
IMPORTANT:
Ensure that retaining bracket (B) engages slot (C) in the
bracket.
11. Install rod (D) through the retaining bracket and the
weights. Use spacers (E) as needed.
12. Secure the rod with nuts (F). Tighten the nuts.
IMPORTANT:
Ensure that nuts (F) are flush with the rod.
215981
ASSEMBLING WINDROWER
Figure 3.43: Bezel Assembly Separated
F
Figure 3.44: Ballast Weights Installed
Figure 3.45: Base Ballast Kit Installed – 163 kg
(360 lb.)
36
B
B
A
E
B
D
C
E
A
F
B
C
D
F
E
A
E
Revision A