MacDon M1170 Unloading And Assembly Instructions page 113

DANGER
Ensure that all bystanders have cleared the area.
1. Shut down the engine, and remove the key from the ignition.
2. Windrowers without the self-aligning center-link kit:
Remove pin (A) and raise center-link (B) until the hook is
above the attachment pin on the header. Replace pin (A) to
hold the center-link in place.
IMPORTANT:
Ensure that the center-link is positioned high enough that it
does not contact the header as the windrower approaches
the header.
3. Remove hairpin (A) from clevis pin (B), and remove the pin
from header support (C). Repeat this step on the other side
of the header.
4. Start the engine.
215981
ATTACHING HEADERS TO WINDROWER
105
A
Figure 5.59: Hydraulic Center-Link
C
A
Figure 5.60: Header Support
B
B
Revision A