Attaching D1X And D1Xl Series Draper Header - MacDon M1170 Unloading And Assembly Instructions

3. Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn't snag the windrow, install the
clevis pin on the outboard side of the draper header
support.
4. Secure clevis pin (C) with hairpin (D).
5. Repeat Step 2, page 92
remaining draper header support.

Attaching D1X and D1XL Series Draper Header

The windrower's support feet and center-link will need to be connected to the draper header. The windrower may be
equipped with an optional self-aligning hydraulic center-link, which allows control over the vertical position of the center-
link from the cab.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
NOTE:
Draper header supports must be installed onto the windrower lift linkage before starting this procedure. For instructions,
refer to Attaching Draper Header Supports, page
1. Shut down the engine, and remove the key from the ignition.
215981
ATTACHING HEADERS TO WINDROWER
to Step 4, page 93 to install the
92.
D
C
Figure 5.30: Draper Header Support
93
A
B
Revision A