MacDon M1170 Unloading And Assembly Instructions page 110

6. Retrieve draper drive and reel control multicoupler (A) from
the hydraulic hose management system.
7. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
8. Open cover (D) and position the coupler onto the
receptacle. Align the pins in the coupler with the slots in
handle (C) and push the handle toward the windrower so
that the coupler locks onto the receptacle and knob (B)
pops out.
9. Remove hose quick disconnect (F) from its storage location.
Connect the quick disconnect to the receptacle on
the frame.
NOTE:
Hose quick disconnect (F) is only present on M1170
Windrowers with the R1 Series Hydraulic Drive kit
(MD #B6845) installed.
10. Remove the cover from electrical connector (E). Push the
electrical connector onto the receptacle. Secure the
connector by turning the collar on the electrical connector
clockwise.
11. Retrieve knife and reel drive multicoupler (A) from the
hydraulic hose management system.
12. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
13. Open cover (D) and position the coupler onto the
receptacle. Align the pins in the coupler with the slots in
handle (C), and push the handle toward the windrower so
that the coupler locks onto the receptacle and knob (B)
snaps out.
215981
ATTACHING HEADERS TO WINDROWER
102
A
E
D
Figure 5.52: Draper/Reel Multicoupler
A
D
Figure 5.53: Knife/Reel Drive Multicoupler
C
B
F
C
B
Revision A