Installing rear ballast
1. Refer to Table
3.1, page 34
2. Move latch (A) towards the right cab-forward side of the
windrower.
3. Grasp louver (B), and lift the hood to open it.
4. Remove eight hex flange bolts (A).
5. Gently pull light bezel assembly (B) so that plugs P215 (C)
and P210 (D) can be disconnected from the back of the red
tail/brake lights inside the bezel.
6. Remove light bezel assembly (B).
7. Separate light bezel assembly (A) by removing six hex
screws (B).
215981
ASSEMBLING WINDROWER
to determine the amount of ballast to add to the windrower.
B
Figure 3.40: Engine Compartment Hood
A
C
Figure 3.41: Rear Light Bezel Attached to Windrower
Figure 3.42: Bezel Assembly Removed from
Windrower
35
A
A
B
A
B
A
D
A
Revision A