MacDon M1170 Unloading And Assembly Instructions page 104

7. Press scroll knob (A) on the HPT to display the
QuickMenu page.
8. Rotate scroll knob (A) to highlight HEADER FLOAT
symbol (B) and press the scroll knob to select it.
9. On the FLOAT ADJUST page, press soft key 3 (A) to disable
the float.
10. Windrowers equipped with the self-aligning
center-link kit:
a. Press HEADER DOWN switch (E) on the ground speed
lever (GSL) to fully retract the header lift cylinders.
b. Press REEL UP switch (B) on the GSL to raise the center-
link until the hook is above the attachment pin on the
header.
IMPORTANT:
If the center-link is too low, it may contact the header as the
windrower approaches the header.
215981
ATTACHING HEADERS TO WINDROWER
96
B
Figure 5.36: HPT Display
Figure 5.37: HPT Display
F
C
E
Figure 5.38: GSL Switches
A - Reel Down
C - Header Tilt Down
E - Header Down
A
A
B
A
D
B - Reel Up
D - Header Tilt Up
F - Header Up
Revision A