Chapter 5: Attaching Headers To Windrower; Attaching Headers To Windrower; A40Dx Auger Header; Attaching A40Dx Auger Header - MacDon M1170 Unloading And Assembly Instructions

Chapter 5: Attaching Headers to Windrower

This section details the steps needed to attach various MacDon headers to the windrower. Be sure to follow only the steps
that apply to your particular header and windrower configuration.

5.1 Attaching Headers to Windrower

Refer to this chapter for instructions on attaching MacDon headers to the windrower.

5.1.1 A40DX Auger Header

This section details the procedures necessary to physically attach an A40DX Auger Header to the windrower and to
complete its hydraulic and electrical connections.

Attaching A40DX Auger Header

The windrower's support feet and center-link will need to be connected to the auger header. The windrower may be
equipped with an optional self-aligning hydraulic center-link, which allows control over the vertical position of the center-
link from the cab.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, stop the engine and remove the key
from the ignition before leaving the operator's seat.
1. Remove hairpin (A) from pin (B). Remove the pin from
header supports (C) on both sides of the header.
DANGER
Ensure that all bystanders have cleared the area.
2. Start the engine.
215981
C
Figure 5.1: Header Support
81
A
B
Revision A