MacDon M1170 Unloading And Assembly Instructions page 108

DANGER
Ensure that all bystanders have cleared the area.
20. Start the engine and press HEADER DOWN switch (A) on
the GSL to fully lower the header.
21. Press rotary scroll knob (A) on the HPT to highlight the
QuickMenu options.
22. Rotate scroll knob (A) to highlight HEADER FLOAT
symbol (B) and press the scroll knob to select it.
23. Turn scroll knob (A) to highlight left float (B) or right
float (C). Press knob (A) to activate the selection.
24. Rotate scroll knob (A) to adjust the float setting. Press the
knob to confirm the setting.
IMPORTANT:
Adjusting the float by increments of 1.0 (out of 10) changes
the header weight at the cutterbar by approximately 91 kg
(200 lb.). Adjust the float in increments of 0.05 to fine-tune
the header's performance.
25. Shut down the engine, and remove the key from
the ignition.
26. Grasp one end of the draper header and lift it. The lifting
force should be 357 N (80 lbf). Repeat this step on the
other side of the header.
27. Proceed to Connecting D1X and D1XL Series Draper Header
Hydraulic and Electrical Systems, page
215981
ATTACHING HEADERS TO WINDROWER
101.
100
A
Figure 5.46: GSL
B
Figure 5.47: HPT Display
B
C
Figure 5.48: HPT Display
A
A
Revision A