D1X And D1Xl Series Draper Header; Attaching Draper Header Supports - MacDon M1170 Unloading And Assembly Instructions

6. Attach the forming shield to spacer (B) on the windrower
leg. Secure the forming shield with retained clevis pin (A).
Secure the clevis pin with the retained lynch pin.
7. Repeat the previous step to secure the other side of the
forming shield.

5.1.2 D1X and D1XL Series Draper Header

This section details the procedures necessary to physically attach a D1X or D1XL Series Draper Header to a windrower and
to complete its hydraulic and electrical connections.

Attaching Draper Header Supports

Draper header supports are required to attach the header to the windrower.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
1. Shut down the engine, and remove the key from the ignition.
2. Remove the hairpin from clevis pin (B) on draper header
support (A). Remove clevis pin (B).
215981
ATTACHING HEADERS TO WINDROWER
92
B
Figure 5.28: Forming Shield Secured to Windrower Leg
A
Figure 5.29: Draper Header Support
A
B
Revision A