Sun Microsystems Netra 440 Service Manual page 163

I
installing
air filter, 52
alarm card, 103
ALOM system controller card, 98
CPU/memory module, 80
DIMMs, 85
DVD drive, 56
DVD slot cover, 55
fan tray 3, 76
fan trays (0-2), 39
hard drives, 49
memory modules, 85
motherboard, 114
PCI card, 92
power distribution board, 107
power supplies, 43
SCSI backplane, 73
system configuration card, 59
system configuration card (SCC) reader, 67
internal components
location, 19
J
J18 connector on fan tray 3
location, 62
L
LEDs, 4
Activity (fan tray 0-2 LED), 8
Activity (hard drive LED), 7
Activity (system status LED), 6, 24
alarm
description, 9
location, 4, 9
states, 10
back panel, 14
enclosure status
description, 5, 15
location, 4, 14
Ethernet connection
description, 14
location, 14
fan trays (0-2)
location, 4, 8
front panel, 4
hard drive
description, 7
location, 4, 7
Locator (system status LED), 6
network management port (NET MGT)
description, 15
location, 14
OK-to-Remove (hard drive LED), 7
Power OK (power supply LED), 26
power supply
description, 15
location, 14
Service Required (fan tray 0-2 LED), 8
Service Required (hard drive LED), 7
Service Required (system status LED), 6
local graphics monitor
remote power-off, 27, 28
remote power-on, 25
location
air diverter, 69
air filter, 51
alarm card, 102
DVD drive, 55
fan cable, 61, 75
fan trays (0-2), 37
hard drives, 47
J18 connector on fan tray 3, 62
P1 connector on motherboard, 62
SCSI backplane, 61, 69, 75
system configuration card (SCC) reader, 58
M
MAC addresses, on system configuration card, 57
major, alarm LED, 10
memory interleaving, 82
memory modules
description, 81
installing, 85
part number, 82
removing, 83
minor, alarm LEDs, 11
motherboard
connectors, 138
installing, 114
Index 145