Figure 4-33 Removing A Power Supply Unit - Sun Microsystems Netra 440 Service Manual
Hide thumbs
Also See for Netra 440:
- Diagnostics and troubleshooting manual (176 pages) ,
- Installation manual (136 pages) ,
- Product overview (62 pages)
Table of Contents
Advertisement
4. Disengage all of the power supplies from the power distribution board.
a. Go to the back of the system and pull the lever on the power supply to the
right (
FIGURE 4-33
This disconnects the power supply from the power distribution board.
Power supply
Removing a Power Supply Unit
FIGURE 4-33
b. Pull the power supply out of its bay just enough to disengage the power supply
connectors from the power distribution board connectors.
Leave the power supply in its bay, but disconnected from the power distribution
board.
c. Repeat
Step a
and
).
Step b
for the remaining three power supplies.
Chapter 4 Removing and Replacing Cold-Swappable Components
Lever
105
Advertisement
Table of Contents
