Sun Microsystems Netra 440 Service Manual page 43

Powering On the System Remotely
Do not use this power-on procedure if you have just added any new internal option
or external storage device, or if you have removed a storage device without
replacing it. To power on the system under those circumstances, you must initiate a
reconfiguration boot. For those instructions, see
on page 28.
To issue software commands, you need to set up an alphanumeric terminal
connection, a local graphics monitor connection, ALOM connection, or a TIP
connection to the Netra 440 server. See the Netra 440 Server Installation Guide for
more information about connecting the Netra 440 server to a terminal or similar
device.
Caution – Before you power on the system, ensure that the system doors and all
panels are properly installed.
Caution – Never move the system when the system power is on. Movement can
cause catastrophic hard drive failure. Always power off the system before moving it.
1. Log in to the ALOM.
Refer to the Advanced Lights Out Manager Software User's Guide for the Netra 440 Server
(817-5481-xx) for more information.
2. Type the following command:
sc> poweron
"Initiating a Reconfiguration Boot"
Chapter 2 Preparing to Service the System 25