Fujitsu ETERNUS LT160 User Manual page 221

External
dimensions
Mass (media excluded) (*5)
Average tape access time
Average tape replacement time
Host interface (up to four
channels)
Component for hot swap
Robot controller
Number of transport robots
Input voltage
Number of phases
Power frequency
AC input system
Power consumption (max)
Other interfaces
*1: To increase the number of cartridge volumes to be stored to 182 or 221, add separate
*2: Two magazines for holding cartridges are supplied with the library.
*3: The capacity value is calculated by assuming that 1 Tbyte = 1000
*4: The performance of data transfer speed depends on the data compression rate and
*5: The mass is the value with the maximum configuration for each model.
*6: The number of PDUs to be installed depends on the number of drives that will be
C144-E072-01EN
Item
Height
Width
Depth
cell options.
tape block size.
installed.
B.1 Library/Drive Specifications
Specification
1800 mm
780 mm
1130 mm
527 kg
7 seconds
12 seconds
Fiber channel (FC_AL/FC_Fablic)
Tape drive/cooling fan
1 unit
1 unit
200-240V AC
Single phase (with FG)
50-60Hz
1 - 4 (*6)
1.9 KW
10Base-T/100Base-TX
4
bytes
B-3