Table of Contents
Advertisement
3) Make settings for each item.
4) Click the [OK] button after all settings are completed. To restore the conditions
5) After clicking the [OK] button, the system displays a confirmation window showing
6) If processing is completed, the system displays a window showing the processing
7) The values that have been set are enabled after settings are completed and the device
C144-E072-01EN
Figure 5.24 Host interface setting window
-
Topology: Select from "Fablic" or "FC_AL".
-
Addressing Mode: This item is enabled if FC_AL is selected in Topology.
Select from "Hard" and "Soft."
-
LOOP ID: This item needs to be specified if "Hard" is set as the Addressing
Mode.
-
Acceptable Host World Wide Port Name: Enter the WWPN of the host that is
permitted to access the setup adapter. Up to eight port names can be entered. In
one text area, up to 16 characters can be entered. Only en-size alphanumeric
characters can be entered. If any character other than alphanumeric characters is
entered, an input error message is displayed.
before the settings, click the [Reset] button.
the input contents. Click the [OK] button if it is OK to proceed. To make entries
again, click the [Back] button.
results. To continue settings of the host interface, repeat the above procedure starting
with 1).
is restarted.
5.5 Setting Library Information
5-33
Advertisement
Table of Contents
Troubleshooting
