Fujitsu ETERNUS LT160 User Manual page 182

Remote Panel Operation
1) Click the [Clean] button displayed under [Operation] to display the following
2) Check the drive to be cleaned and then click the [OK] button. Only one drive can be
3) The selected drive is displayed in the confirmation message window.
4) The system displays a window showing the processing results, completing the
5-44
window.
Figure 5.31 Manual cleaning operation window
Drives to be displayed are as follows:
- Drives from which a cleaning request is reported (Clean Required display)
- Drives that require cleaning (Clean Need display)
If [Clean] is selected when there is no drive that requires cleaning, a
message "Cleaning not needed" is displayed.
specified.
Click the [OK] button if it is OK to proceed. To make selections again, click the
[Back] button.
manual cleaning.
Remarks:
C144-E072-01EN