Plc Configuration (I/O); Configuring K-Bus I/O Modules - Kontron ThinkIO-P Manual

CoDeSys PLC
6.2

PLC Configuration (I/O)

6.2.1

Configuring K-Bus I/O Modules

On the left side of the CoDeSys main display window there is a box called the resources area,
at the bottom of which there are four selection tabs. The right most tab is the Resources tab.
The following procedure begins with the selection of this tab.
To add and configure K-Bus I/O modules using the K-Bus configurator, perform the following:
PROCEDURE START: Configuring K-Bus I/O modules
1. Initial screen (same as in section 6.1, after step 8)
2. Click the Resources tab
Page 16
PROGRAMMING ASSISTANCE GUIDE
© 2007 Kontron Modular Computers GmbH
ThinkIO ™ - P
ID 29867.06, Rev. 01